Preparing Your Chainsaw for Firewood Season: Bar, Chain & Fuel Checks
Before cutting firewood, first check the bar and chain, fuel, and chain oil for faster, safer work.
Check that the chain cutters are sharp
If the saw produces fine powder instead of long chips, or you have to press down to make it cut, the chain is dull. Use the correct file for the chain type and sharpen every cutter at the same angle with the same number of strokes.
Clean the bar groove and sprocket
Scrape sawdust and oily residue from the guide-bar groove and make sure the oil hole is clear. Occasionally flipping the bar reduces uneven wear on one side.
Adjust the chain tension
Tighten the chain until it does not sag beneath the bar, but can still be pushed around the top of the bar by a gloved hand. A new chain stretches during initial use, so check it frequently.
Fill both fuel and chain oil
Prepare fresh fuel mix at 50:1 with Husqvarna 2-stroke oil, and fill the chain-oil tank whenever you refuel. During operation, briefly run the saw with the bar tip pointed at a light-colored surface. A line of oil indicates that the chain oil is flowing properly.
Test the chain brake
Before work, verify that the chain brake engages properly. If it does not engage or the chain continues moving after it engages, stop using the saw and have it repaired.
Clear the firewood-cutting area
Place the log on a support, such as a sawbuck, to keep it off the ground, and clear rocks and branches from around your feet. Contact with soil or stone will dull the chain instantly.
For questions about product selection or after-sales service, call Customer Service at 1577-6310, extension 1. Support · Product Instructions · Safety & Certification